You issue the following commands on SwitchA and SwitchB, which are Cisco Nexus 7000 Series switches:

SwitchA(config)#vpc domain 101

SwitchA(config-vpc-domain)#peer-keepalive destination 192.168.1.2 source

192.168.1.1 vrf default

SwitchA(config-vpc-domain)#exit

SwitchA(config)#interface range ethernet 2/1 - 2

SwitchA(config-if-range)#switchport

SwitchA(config-if-range)#channel-group 1 mode active

SwitchA(config-if-range)#interface port-channel 1

SwitchA(config-if)#switchport mode trunk

SwitchB(config)#vpc domain 101

SwitchB(config-vpc-domain)#peer-keepalive destination 192.168.1.1 source

192.168.1.2 vrf default

SwitchB(config-vpc-domain)#exit

SwitchB(config)#interface range ethernet 2/1 - 2

SwitchB(config-if-range)#switchport

SwitchB(config-if-range)#channel-group 1 mode active

SwitchB(config-if-range)#interface port-channel 1

SwitchB(config-if)#switchport mode access

Which of the following is most likely a problem with this configuration?

Choose the correct option from the given list.

The Ethernet port range is using the wrong channel group mode on SwitchB.

The vpc peer-link command is missing from SwitchA.

The vpc peer-link command must be issued on both switches.

Port-channel 1 on both switches should be an access port.

The vPC domain ID on SwitchB should be a different value.

01 / 174

Trending Exams